DC MOTOR DRIVER USING MICROCONTROLLER
Interfacing DC Motor with 8051 Microcontroller using L293D
So, we use motor driver circuit in between a DC motor and the microcontroller. Also read the interesting concept: Interfacing 7 Segment Display to 8051 Microcontroller Here, we are using L293D and L298N motor driver ICs to drive DC motors.
PWM Based DC Motor Speed Control using Microcontroller
PWM based DC Motor Speed Control using Microcontroller Circuit Design. The circuit consists of one 8051 Microcontroller (and its supporting circuitry related to oscillator and reset), L298N Motor Driver Module, a DC Motor and a few push buttons. A 12V DC Motor is connected to the L298N Motor Driver Module at its OUT1 and OUT2 Pins.
Interfacing DC Motor with PIC Microcontroller using L293D
Note: VDD and VSS of the pic microcontroller is not shown in the circuit diagram should be connected to +5V and VSS to GND. We can drive two DC Motors with one L293D, in this example we are using only the first pair of drivers to drive one DC Motor.
DC Motor Interfacing using L293D with PIC18F4550
To interface the DC motor with a microcontroller we need to use a driver circuit or driver IC. L293D is a dual H-bridge, high current motor driver Integrated Circuit. It acts as a current amplifier as it takes a low current input signal from the microcontroller and provides high current output to the motor.
Interfacing DC Motor with 8051 using L293D AT89C51 Keil C
DC Motor can be easily interfaced with 8051 or AT89C51 microcontroller using L293D Quadruple Half H Bridge driver and the programming is done using Keil C.
DC MOTOR INTERFACING WITH 8051 microcontroller
This article will demonstrate how to control the DC motor using AT89C51 Microcontroller. MOTOR DRIVER for dc motor interfacing with 8051 microcontroller. To overcome the problems in their interfacing, a motor Driver IC is connected between microcontroller and DC motor. Motor driver is a
Dual DC Motor driver using two L293D - PIC Microcontroller
Dual DC Motor driver using two L293D IC. The L293D device is quadruple high-current half-H driver. The 293D is designed to provide bidirectional drive current up to 600mA a voltage from 5V to 36V. It provides 600mA +600mA on each channel suitable for mini hobby robots. The board been designed mainly for small size robot, 
DC Motor Speed Control using Pic microcontroller - PWM method
This tutorial is about dc motor speed control with a pic microcontroller using the PWM method. There are many applications of DC motors, where we need a variable speed of DC motor. For example, it has applications in electric cars, trucks, and aircraft.
DC motor Interfacing with PIC Microcontroller - OpenLabPro
DC Motor Interfacing with PIC Microcontroller. DC motors need much more current than a microcontroller can provide, so it needs separate drivers. Different DC motors need different voltages and operating high voltage motor from a low voltage controller is not a feasible option. Following things should be taken into account while designing the
DC motor Interfacing with 8051 Microcontroller using L293D
For example, consider the DC motor whose speed or direction of rotation of DC motor can be controlled using programming techniques which can be achieved by interfacing with 8051 microcontroller. So, in this article let us discuss about interfacing DC motor with 8051 microcontroller. Motor Driver IC used for Interfacing DC motor with 8051